Detcon 700 Series Remote Sensor/Alarm Relay Module With H Manual de usuario Pagina 6

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 28
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 5
700 HART-RAM I.M.
5.5"
5.2"
5.825"
Ø0.2750 x2
Mounting
Bolt
Wall (or other
mounting surface)
4.35"
Three - 3/4"NPT Fittings
Explosion Proof Enclosure
Junction-Box
Mounting Holes
Figure 2 HART-RAM Mounting
PGM2
SPAN
Explosion Proof Enclosure
Junction-Box
Sensor Assembly
Splash Guard
(Aluminun Junction-Box shown)
Use Spacers to move
the J-Box and Sensor
Assembly away from the
wall at least 0.25-0.5" to
allow access to Sensor
Wall (or other
mounting surface)
Spacer
PGM2
SPAN
detcon inc.
MODEL
XX-700
PGM1
ZERO
Ø0.275 X2
5.2"
5.5"
5.195"
5.825"
7.76"
2"
12.945"
2.115"
Mounting Holes
Mounting
Bolt
4.35"
3/4" NPT x3
Sensor
Figure 3 Mounting HART-RAM with 700 Sensor
The HART-RAM Electronics package consists of three printed circuit assemblies (PCAs). The top two
PCAs (RAM display and HART Bridge) are accessed by removing the junction box cover and using the
brass pull knobs to pull the package directly out of the enclosure. The bottom PCA (terminal board) will
remain attached to the bottom of the junction box via two machine screws allowing the RAM display and
HART Bridge to unseat from the 12-pin plug-in connector and providing access to the terminal board
700 HART-RAM I.M. Rev. 0.0 Page 2 of 24
Vista de pagina 5
1 2 3 4 5 6 7 8 9 10 11 ... 27 28

Comentarios a estos manuales

Sin comentarios