Detcon 240 Manual de instrucciones descargar pdf (Pagina 14)

Sentinel CX

Sentinel CX Sensor Station IM Rev. 1.2 Page 10 of 10

3. Installation

3.1 Initial Setup

NOTE

The Detcon tripod (P/N 975-TRIPOD-100) provides a stable and mobile base for the

SmartWireless® CX Sensor Station. A maximum of two sensors can be secured to the

tripod using Detcon brackets (P/N 943-004413-000) installed on the tripod

1. Unpack the tripod, open the legs and place on a level surface.

2. Mount the CX to the center pipe using the supplied U-bolts in accordance with Figure 9.

Pipe Mounting U-Bolts

and hardware

Tripod Center Pipe

Figure 9 Mount CX on Tripod

3. Install the 8" antenna on the antenna connector on the top right of the CX controller (Figure 1).

4. Secure the antenna cover over the antenna.

5. If sensors are being mounted on the tripod legs, attach the sensor mounting brackets to the tripod

legs using the supplied

" bolts, nuts and lock washers in accordance with Figure 10.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 25 26

Sin comentarios

Detcon 240 Manual de instrucciones Pagina 14